Product Selection Guide Page 600 Product Selection Guide-11th Edition

Series Number of lamps 1 Lamp type Diffuser Voltage Ballast configuration DMW Wet location For tandem double-length unit, add prefix T. Example: TDMW 1 2 3 Not included. 28T5 28W T5 (46) 32 32W T8 (48) 48T8HO 44W T8HO (48) 54T5HO 54W T5HO (46) 2 96T8 59W T8 slimline (96) 96T8HO 86W T8 380mA (96) (blank) High-impact acrylic, 50% DR ARDP Deep high-impact acrylic, 50% DR 3 MVOLT 120 277 347 (blank) Standard configuration 1/3 One 3-lamp ballast 1/4 One 4-lamp ballast Ballast Options GEB10IS T8 electronic ballast, 10% THD, instant start GEB10RS T8 electronic ballast, 10% THD, programmed rapid start (347V only) GEB10PS Electronic ballast, 10% THD, programmed rapid start GEB10PS90 T5HO 90 electronic ballast, 10% THD, programmed rapid start BCD Mounting bracket to chain hang DMW (2 per package, excludes chain) 4, 5 HC36 Wire hook and 36" chain set (2 per package) 4, 5 MSI_ Wet location occupancy sensor pre-wired 6, 7 IP67 IP67 rated, utilizes 8 latches for 4 fixtures and 14 latches on 8 fixtures STSL Stainless steel latches WLF Wet location fittings (one pair, installed top, for use with 1/2 rigid conduit) CSA Meets Canadian standards (347V only) NOM Meets Mexican standards PRODUCT INFORMATION PSG11 ORDERING INFORMATION Specifications subject to change. Example: DMW 2 32 MVOLT GEB1015 ENCLOSED AND GASKETED Intended Use Intended for low to medium mounting heights where dust, dirt, humidity, or moisture are present. Ideal for canopies, dock areas, wastewater treatment, refrigerated areas, food processing, and other non-hazardous environments. Features polyester housing with cold rolled steel channel and diffuser to spread lamp range Listed, CSA with standard ballast, sound rated A wall) or suspended mounted. Wall mounting; horizontal orientation only for use in damp locations Listings 120V, 277V, and MVOLT are UL Listed and CSA Certified (standard), 347V is CSA Certified (see Options). NOM Certified (see Options). Listed for 25C ambient and wet locations for covered ceiling applications. IP65 rated standard. Optional IP67 rating available (supplied with 8 latches on 4 units and 14 latches on 8 units; covered ceiling not required). Compliant to FDA/USDA requirements and/or NSF splash zone certification. DMW Wet Location www.lithonia.com Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions are shown in inches (centimeters) unless otherwise noted. ADDITIONAL INFORMATION For additional product information, visit www.lithonia.com. CONFIGURATIONS SERIES LAMPS PER CROSS SECTION LAMPS PER FIXTURE LAMP TYPE WIDTH DEPTH LENGTH DMW 1, 2, 3 28T5, 32 7-5/8 (19.4) 4-3/4 (12.1) 50 (127.0) DMW 1, 2 54T5HO 7-5/8 (19.4) 4-3/4 (12.1) 50 (127.0) DMW (ARDP) 1, 2, 3 1, 2, 3 28T5, 32 7-5/8 (19.4) 5-5/8 (14.3) 50 (127.0) DMW (ARDP) 1, 2 1, 2 54T5HO 7-5/8 (19.4) 5-5/8 (14.3) 50 (127.0) DMW 2 48T8HO 7-5/8 (19.4) 5-5/8 (14.3) 50 (127.0) DMW 1, 2 96T8, 96T8HO 7-5/8 (19.4) 5-5/8 (14.3) 98 (248.9) TDMW 1, 2 2, 4 28T5, 54T5HO 7-5/8 (19.4) 5-5/8 (14.3) 98 (248.9) TDMW 1, 2, 3 2, 4, 6 28T5,32 7-5/8 (19.4) 5-5/8 (14.3) 98 (248.9) Notes 1 See Configurations table for lamp compatibility. 2 Must use GEB10PS90 ballast. 3 Deep lens is standard on 4 48T8HO, and on all 8 fixtures. To match deep appearance on all other 4 units, order ARDP lens. 4 Order accessories as separate catalog numbers. 5 For stainless steel, specify STS (example: BCD STS). 6 Must specify voltage. 7 For mounting up to 8 specify MSI8; for mounting up to 20 specify MSI20. Certain airborne contaminants can diminish integrity of acrylic and polycarbonate. Refer to the Acrylic & Polycarbonate Environmental Compatibility tables on pages 1116-1117 for suitable uses. LITHONIA LIGHTING DEMANDING ENVIRONMENTS W D 600

Previous Page
Next Page