Product Selection Guide Page 452 Product Selection Guide-11th Edition

PRODUCT INFORMATION PSG11 452 LIGHT COMMERCIAL Intended Use Ideal for a wide variety of low- to medium-height ceiling applications including commercial, retail and hospitality spaces where open reflectors are required. Features Galvanized steel mounting frame with mechanical trim retention (yoke) ensures secure and flush reflector mount- ing to ceiling Mounting frame has cutout section for remodel applications when installation from below is necessary Frames equipped with galvanized junction box UL Listed for through wire applications Maximum 1-1/2" ceiling thickness Aluminum full reflectors are optically designed to maximize lumen output and to provide superior glare control Black or white baffled reflectors have a semi-specular upper finish with a white painted flange standard Listings Fixtures are UL Listed for through-branch wiring, NON-IC recessed mounting, damp location, and to U.S. and Canadian safety standards. 6HF 2/DTT ADDITIONAL INFORMATION For additional product information, visit www.lithonia.com. 6" Horizontal www.lithonia.com Notes 1 Not available with ADEZ or ECOS. 2 Electronic multi-volt ballast capable of operating any line voltage from 120-277V, 50 or 60Hz. 3 Not available with EL or ELR. 4 For additional options, see www.lithonia.com. 5 Ships standard for 1-lamp operation. For 2-lamp operation, consult installation instructions or factory. Add 3"(7.6) to width and 4-1/2"(11.4) to length. 6 Not recommended for field installation. Series Wattage/ Lamp Reflector/Color Lens type Voltage Options 4 6HF 2/13DTT 1 2/18DTT 2/26DTT Choose reflector below. Housing and reflector may be ordered separately. Lamp types and maximum wattages are listed for each reflector. (blank) No lens CGL Clear glass lens T73 Tempered glass prismatic lens PCL Clear polycarbonate lens MVOLT 2 120 277 347 3 ADEZ Advance Mark 10 electronic dimming ballast, 120V or 277V. Minimum dimming level 5%. Must be wattage and voltage specific. ECOS Lutron EcoSystem electronic dimming ballast, 120V - 277V. Must be wattage specific. Minimum dimming level 5%. EL Emergency PSDL3 DL battery pack with integral test switch 5 ELR Emergency PSDL3 DL battery pack with remote test switch 5 ELRHL2LP IOTA I-162 emergency battery pack with remote test switch. Operates two 26W, two 32W or two 42W CFL lamps in emergency mode with battery back-up in case of power disruption. Average output is 2,600 lumens for two 26W lamps; 2,750 lumens for two 32W lamps and 2,800 lumens for two 42W lamps. 6 GMF Single slow-blow fuse, must specify voltage BDP Ballast disconnect plug (meets codes that require in-fixture disconnect) 3 RIF1 Radio interference filter WLP 35K lamp (shipped separately) ORDERING INFORMATION Specifications subject to change. Example: 6HF 2/26DTT F6B3 MVOLT Baffle reflector/Color Open reflector/Color Wallwash reflector/Color Wet lens reflector/Color F6B3 Black baffle F6B3W White baffle F6O22 White open F6O2A Clear diffuse open F6O2AZ Clear semi-diffuse open F6O2GZ Gold semi-specular open F6O2PR Pewter diffuse open F6OTWTZ Wheat semi-specular open F6W1 White F6W1A Clear diffuse F6W1AZ Clear semi-specular F6W1G Gold diffuse F6W1GZ Gold semi-specular F6W1PR Pewter diffuse F6W1WTZ Wheat semi-specular F6LF1 White splay, clear lens F6LFB1 Black baffle, clear lens F6L4 White splay, fresnel lens F6LB4 Black baffle, fresnel lens F6LF73 White splay, tempered prismatic lens F6LTFB73 Black baffle, tempered prismatic lens F6L D3 White splay, drop opal lens F6L DB3 Black baffle, drop opal lens 7-1/2 (19.1) 6-3/8 (16.2) 11-3/8 (28.9) 13-1/4 (33.7) 12-1/4 (31.1) 8-3/4 (22.2) Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions are shown in inches (centimeters) unless otherwise noted. 6-3/8 (16.2) 6-1/8 (15.6) 7-1/2 (19.1) Specifications Max. height: 6-3/8 (16.2) Ceiling opening: 7 (17.8) Overlap trim: 7-1/2 (19.1) Length: 13-1/4 (33.7) Width: 12-1/4 (31.1) LITHONIA LIGHTING COMMERCIAL DOWNLIGHTING

Previous Page
Next Page