Product Selection Guide Page 447 Product Selection Guide-11th Edition

Intended Use Ideal for a wide variety of low- to medium-height ceiling applications including commercial, retail and hospitality spaces where open, baffled, wallwash and lensed reflectors are required. Features 16-gauge flat barhangers (included), C channels or 1/2 steel conduit lengths Listings Fixtures are UL Listed for through-branch wiring, NON-IC recessed mounting, damp location, and to U.S. and Canadian safety standards. LP8FN 1-Lamp, Double Twin-Tube (DTT) 1-Lamp, Triple-Tube (TRT) PRODUCT INFORMATION 447 PSG11 ADDITIONAL INFORMATION For additional product information, visit www.lithonia.com. SPECIFICATION 8 Vertical www.lithonia.com LITHONIA LIGHTING COMMERCIAL DOWNLIGHTING Notes 1 Not available with ECOS or WLP. 2 Not available with 347V, ECOS, EL or ELR. 3 Damp lens available with open reflectors. 4 Electronic multi-volt ballast capable of operating any line voltage from 120-277V, 50 or 60Hz. 5 Not available with EL or ELR. 6 Add 3" (7.6) to width and 4-1/2" (11.4) to length. 7 Not recommended for field installation. 8 White painted flange (TRW) standard. 9 Lensed reflectors are wet location listed. STANDARD PACKAGING To order , use single master catalog number. Example: (13) LP8FN 26-42TRT 8O2A MVOLT Fixtures ship as multiple components using optimized packaging. Example above ships as: (Qty 13) LP8FN 26-42TRT MVOLT (13 cartons of one housing) (Qty 13) 8O2A (13 cartons of one reflector) Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions are shown in inches (centimeters) unless otherwise noted. 9-1/2" 12-3/8" 26DTT 57TRT 26DTT 57TRT 26DTT 57TRT 26DTT 57TRT Series Lamp type Reflector Lens 3 Voltage Options LP8FN 18DTT 26DTT 18TRT 26-42TRT 1 26TRT 32TRT 42TRT 57TRT 2 Choose reflector below. Housing and reflector may be ordered separately. Lamp types and maximum wattages are listed for each reflector CGL Clear glass lens T73 Tempered glass prismatic lens PCL Clear polycarbonate lens MVOLT 4 120 277 347 5 ADEZ Advance Mark 10 electronic dimming ballast, 120V or 277V. Must be wattage and voltage specific. Minimum dimming level 5% ECOS Lutron EcoSystem electronic dimming ballast, 120V - 277V. Must be wattage specific. Minimum dimming level 5% EL Emergency PSDL3 DL battery pack with integral test switch. Lens removal required before EL testing 6 ELR Emergency PSDL3 DL battery pack with remote test switch 6 ELHL IOTA I-420-R High lumen output emergency battery pack. Internal test switch provided. Maximum average lumen output is 1300 (42W) 7 ELRHL IOTA I-420-EM-B High lumen output emergency battery pack. Remote test switch provided. Maximum average lumen output is 1300 (42W) 7 GMF Single slow-blow fuse, must specify voltage BDP Ballast disconnect plug (meets codes that require in-fixture disconnect) WLP 35K lamp (shipped separately) TRW White flange with anodized reflectors RIF1 Radio interference filter NEPP Interface for Sensor Switch nLight network with integral power supply. Refer to TN-623-01. LBH Less barhangers ORDERING INFORMATION Specifications subject to change. Example: LP8FN 26-42TRT 8O2A MVOLT Open reflector Baffle with specular upper reflector Wallwash with integral kicker Glass lens 8O2 White 3 8O2A Clear diffuse 3 8O2AZ Clear semi-specular 3 8O2G Gold diffuse 3 8O2GZ Gold semi-specular 3 8O2PR Pewter diffuse 3 8O2WTZ Wheat semi- specular 3 8B3 Black baffle 8 9-1/2" 12-3/8" 8B3W White baffle 8 8W1 White 9-1/2" 12-3/8" 8W1A Clear diffuse 8W1AZ Clear semi- specular 8W1G Gold diffuse 8W1GZ Gold semi- specular 8W1PR Pewter diffuse 8W1WTZ Wheat semi- specular 8LF1 White splay, clear lens 8,9 9-1/2" 12-3/8" 8LFB1 Black baffle, clear lens 8,9 8L4 White splay, fresnel lens 8,9 8LB4 Black baffle, fresnel lens 8,9 8LF73 White splay, tempered prismatic lens 8,9 8LFB73 Black baffle, tempered prismatic lens 8, 9 12-3/8 (31.4) 9-1/2 (24.1) 13 (33.0) 15 (38.1)

Previous Page
Next Page