Product Selection Guide Page 445 Product Selection Guide-11th Edition

PRODUCT INFORMATION 445 PSG11 ADDITIONAL INFORMATION For additional product information, visit www.lithonia.com. SPECIFICATION 8 Horizontal www.lithonia.com Open reflector Baffle with specular upper reflector Wallwash with integral kicker Glass lens with specular upper reflector F8O2 White 2 F8O2A Clear diffuse 2 F8O2AZ Clear semi-specular 2 F8O2G Gold diffuse 2 F8O2GZ Gold semi-specular 2 F8O2PR Pewter diffuse 2 F8O2WTZ Wheat semi-specular 2 F8B3 Black baffle 7 F8B3W White baffle 7 F8W1 White F8W1A Clear diffuse F8W1AZ Clear semi-specular F8W1G Gold diffuse F8W1GZ Gold semi-specular F8W1PR Pewter diffuse F8W1WTZ Wheat semi-specular F8LF1 White splay, clear lens 7,8 F8LFB1 Black baffle, clear lens 7,8 F8L4 White splay, fresnel lens 7,8 F8LB4 Black baffle, fresnel lens 7,8 F8LF73 White splay, tempered prismatic lens 7,8 F8LFB73 Black baffle, tempered prismatic lens 7,8 2/26DTT 6-3/8" 9-1/2" 6-3/8" 9-1/2" 6-3/8" 9-1/2" 6-3/8" 9-1/2" Series Lamp type Reflector Lens Voltage Options LF8N 2/13DTT 1 2/18DTT 2/26DTT Choose reflector below Housing and reflector may be ordered separately. Lamp types and maximum wattages are listed for each reflector. CGL Clear glass lens T73 Tempered glass prismatic lens PCL Clear polycarbonate lens MVOLT 3 120 277 347 4 ADEZ Advance Mark 10 electronic dimming ballast, 120V or 277V. Must be wattage and voltage specific. Minimum dimming level 5% ECOS Lutron EcoSystem electronic dimming ballast, 120V - 277V. Must be wattage specific. Minimum dimming level 5% EL Emergency PSDL3 DL battery pack with integral test switch 4 ELR Emergency PSDL3 DL battery pack with remote test switch 4 ELRHL2LP IOTA I-162 Emergency battery pack with remote test switch. Operates two 26W CFL lamps in emergency mode with battery back-up in case of power disruption. Average lumen output is 2600 6 GMF Single slow-blow fuse, must specify voltage BDP Ballast disconnect plug (meets codes that require in-fixture disconnect) 4 TRW White flange with anodized reflectors WLP 35K lamp (shipped separately) RIF1 Radio interference filter NEPP Interface for Sensor Switch nLight network with integral power supply. Refer to TN-623-01. LBH Less barhangers ORDERING INFORMATION Specifications subject to change. Example: LF8N 2/26DTT F802A MVOLT Intended Use Ideal for a wide variety of low- to medium-height ceiling applications including commercial, retail and hospitality spaces where open, baffled, wallwash and lensed reflectors are required. Features with mechanical trim retention (yoke) ensures secure and flush reflector mounting to ceiling 16-gauge flat barhangers (included), C channels or 1/2 steel conduit Listings Fixtures are UL Listed for through-branch wiring, NON-IC recessed mounting, damp location, and to U.S. and Canadian safety standards. LF8N 2-Lamp, Double Twin-Tube (DTT) STANDARD PACKAGING To order , use single master catalog number. Example: (13) LF8N 2/26DTT F8O2A MVOLT Fixtures ship as multiple components using optimized packaging. Example above ships as: (Qty 13) LF8N 2/26DTT MVOLT (13 cartons of one housing) (Qty 13) F8O2A (13 cartons of one reflector) Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions are shown in inches (centimeters) unless otherwise noted. 6-3/8 (16.2) 9-1/2 (24.1) 13-7/8 (35.2) 15 (38.1) Notes 1 Not available with ADEZ or ECOS. 2 Damp lens available with open reflectors. 3 Electronic multi-volt ballast capable of operating any line voltage from 120-277V, 50 or 60Hz. 4 Not available with EL or ELR. 5 Ships standard for one-lamp operation. For two-lamp emergency operation, consult installation instructions or factory. Add 3" (7.6) to width and 4-1/2"(11.4) to length. 6 Not recommended for field installation. 7 White painted flange (TRW) standard. 8 Lensed reflectors are wet location listed. LITHONIA LIGHTING COMMERCIAL DOWNLIGHTING

Previous Page
Next Page