Product Selection Guide Page 444 Product Selection Guide-11th Edition

Open reflector Baffle with specular upper reflector Wallwash with integral kicker Glass lens with specular upper reflector F8O1 White 3 F8O1A Clear diffuse 3 F8O1AZ Clear semi-specular 3 F8O1G Gold diffuse 3 F8O1GZ Gold semi-specular 3 F8O1PR Pewter diffuse 3 F8O1WTZ Wheat semi-specular 3 F8B5 Black baffle 8 F8B5W White baffle 8 F8W4 White F8W4A Clear diffuse F8W4AZ Clear semi-specular F8W4G Gold diffuse F8W4GZ Gold semi-specular F8W4PR Pewter diffuse F8W4WTZ Wheat semi-specular F8LS1 White splay, flat clear lens 8,9 F8LSB1 Black baffle, flat clear lens 8,9 F8LS4 White splay, fresnel lens 8,9 F8LSB4 Black baffle, fresnel lens 8,9 F8LS73 White splay, tempered prismatic lens 8,9 F8LSB73 Black baffle, tempered prismatic lens 8,9 6-3/8" 9-1/2" 6-3/8" 9-1/2" 6-3/8" 9-1/2" 1/57TRT 6-3/8" 9-1/2" PRODUCT INFORMATION PSG11 444 Series Lamp type Reflector Lens 3 Voltage Options LF8N 1/26-42TRT 1 1/26TRT 1/32TRT 1/42TRT 1/57TRT 2 Choose reflector below. Housing and reflector may be ordered separately. Lamp types and maximum wattages are listed for each reflector. CGL Clear glass lens T73 Tempered glass prismatic lens PCL Clear polycarbonate lens MVOLT 4 120 277 347 5 ADEZ Advance Mark 10 electronic dimming ballast, 120V or 277V. Must be wattage and voltage specific. Minimum dimming level 5% ECOS Lutron EcoSystem electronic dimming ballast, 120V - 277V. Must be wattage specific. Minimum dimming level 5% EL Emergency PSDL3 DL battery pack with integral test switch 6 ELR Emergency PSDL3 DL battery pack with remote test switch 6 ELHL IOTA I-420-R High lumen output emergency battery pack. Internal test switch provided. Maximum average lumen output is 1300 (42W) 7 ELRHL IOTA I-420-EM-B High lumen output emergency battery pack. Remote test switch provided. Maximum average lumen output is 1300 (42W) 7 GMF Single slow-blow fuse, must specify voltage BDP Ballast disconnect plug (meets codes that require in-fixture disconnect) 5 TRW White flange with anodized reflectors WLP 35K lamp (shipped separately) RIF1 Radio interference filter NEPP Interface for Sensor Switch nLight network with integral power supply. Refer to TN-623-01. LBH Less barhangers ORDERING INFORMATION Specifications subject to change. Example: LF8N 1/26-42TRT F8O1A MVOLT SPECIFICATION Intended Use Ideal for a wide variety of low- to medium-height ceiling applications including commercial, retail and hospitality spaces where open, baffled, wallwash and lensed reflectors are required. Features with mechanical trim retention (yoke) ensures secure and flush reflector mounting to ceiling 16-gauge flat barhangers (included), C channels or 1/2 steel conduit Listings Fixtures are UL Listed for through-branch wiring, NON-IC recessed mounting, damp location, and to U.S. and Canadian safety standards. ADDITIONAL INFORMATION For additional product information, visit www.lithonia.com. 8 Horizontal www.lithonia.com LF8N 1-Lamp, Triple-Tube (TRT) STANDARD PACKAGING To order, use single master catalog number. Example: (13) LF8N 1/26-42TRT F8O1A MVOLT Fixtures ship as multiple components using optimized packaging. Example above ships as: (Qty13) LF8N 1/26-42TRT MVOLT (13 cartons of one housing) (Qty13) F8O1A (13 cartons of one reflector) 6-3/8 (16.2) 9-1/2 (24.1) 13-7/8 (35.2) 15 (38.1) Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions are shown in inches (centimeters) unless otherwise noted. Notes 1 Not available with ECOS or WLP. 2 Not available with 347, ECOS, EL or ELR. 3 Damp lens only available with open reflectors. 4 Electronic multi-volt ballast capable of operating any line voltage from 120-277V, 50 or 60Hz. 5 Not available with EL or ELR. 6 Add 3" (7.6) to width and 4-1/2" (11.4) to length. 7 Not recommended for field installation. 8 White painted flange (TRW) standard. 9 Lensed reflectors are wet location listed. LITHONIA LIGHTING COMMERCIAL DOWNLIGHTING

Previous Page
Next Page