Product Selection Guide Page 270 Product Selection Guide-11th Edition

PRODUCT INFORMATION PSG11 270 Series Mounting Voltage Configuration (Panels) HXR800 S Surface R Recessed 120 120V 01 Single Panel 14 x 17 Viewing Area 14 x 21 L x H 02 2 Panel 28 x 17 Viewing Area 28 x 21 L x H 03 3 Panel 42 x 17 Viewing Area 42 x 21 L x H 04 4 Panel 56 x 17 Viewing Area 56 x 21 L x H ORDERING INFORMATION Specifications subject to change. Example: HXR800 R 120 02 DARKROOM & X-RAY ILLUMINATORS Intended Use The Economy X-Ray Illuminator offers the same high quality construction as the Techline series but in a simpler design with fewer options. It provides a lower cost alternative to address basic viewing needs. Side-by-side configurations of up to 4 panels are available in a slim-profile, surface or recessed mount, housing. Each panel is uniformly illuminated by two lamps controlled by an independent on/offrocker switch. Features diffuses light wet or dry, with no field adjustment film sizes on a single viewing panel surface-mount version ECONOMY X-RAY ILLUMINATOR Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions (if provided) are shown in inches unless otherwise noted. ADDITIONAL INFORMATION For additional product information, visit www.healthcare-lighting.com. Economy X-Ray Illuminator HEALTHCARE LIGHTING www.healthcare-lighting.com RIGHT VIEW FRONT VIEW 31" 28" 26" 5" 24" 21" (2) Ballast per Panel: Type 1 - 0.70 amps/panel PN - 1031 (2) Switching modules Standard on/off Standard removal access wireway panel Fluorescent lamps included. 2 ea - lamp model #F15T8/D Body is 18 ga welded steel construction 3/8" max dia. for fastening fixture to wall, keyhole 3/16" slot Film Retainer 1 -1/2" recess trim flange is factory attached on each of the four sides of recess mounted configuration Wall Surface Rough-in cut-out dimension: 28 - 3/4" x 21 - 3/4" 16" 12" 2" 1.5" 3" NOTE: DO NOT DISTORT THE FIXTURE. USE SHIMS BETWEEN THE FIXTURE AND THE WALL CUT-OUT FRAMING AT SCREW FASTENING LOCATIONS. 1 inch knock-out typical right hand side is standard location on recess mounted fixtures.

Previous Page
Next Page