Product Selection Guide Page 257 Product Selection Guide-11th Edition

PRODUCT INFORMATION 257 PSG11 Series Options LVC1200 Low Voltage Controller: 2 x Class 2 Circuits JBC Remote Installation Enclosure ORDERING INFORMATION Specifications subject to change. Example: LVC1200 Intended Use Many of our fixtures contain an option for a Low Voltage Controller (LVC) to connect with the nurse call system or to a pil- low switch. The LVC is also available as a separate component. It can be installed in fixtures that require momentary contact switching. Features contact switch (by others)- 4 amps maximum per load, 8 amps total device load normally open momentary contact switches Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions (if provided) are shown in inches unless otherwise noted. ADDITIONAL INFORMATION For additional product information, visit www.healthcare-lighting.com. Notes 1 Codes require line voltage and low voltage to enter and exit enclosure from separate locations, and to be isolated from one another. LOW VOLTAGE CONTROLLER LOW VOLTAGE CONTROLLER Low Voltage Controller HEALTHCARE LIGHTING www.healthcare-lighting.com 1200 Operation: Connect 277VAC 120VAC Line to Black and Orange leads. Cap Yellow lead. Operation: Connect Line to Black and Yellow leads. Cap Orange lead. WARNING: Un-used lead is hot and must be capped Individual Wiring Sequential Wiring Brown Red Black Orange Yellow White Green Load -1 Load -2 Line 277VAC 120VAC Line/Load Ground 2-Loads/(2) 2-Pos Pin Assignments 2 Loads/4-Position Pin Assignments Jumper: 1&3 (1) Load-1: ON Jumper: 1 to 2 Open: 2 (2) Load-2: ON Open: 3 & 4 #1 MCS: 5(Ckt-1) (3) Load- 1&2 ON To MCS: 5 & 6 #2 MCS: 4(Ckt-2) (4) ALL OFF Comm: 6(Ckt-1&2) Load-1: ON/OFF Load-2: ON/OFF (Separately Controlled) 1-1/8" 6 -3/4" 2 -1/8" 1 -1/8" 1 -1/16" 1/2"

Previous Page
Next Page