Product Selection Guide Page 113 Product Selection Guide-11th Edition

PRODUCT INFORMATION 113 PSG11 OPTIONS & ACCESSORIES www.lithonia.com Order RELOC wiring with lay-in troffers and parabolics for use in buildings, schools and retail stores. Access plates have one pre-punched knockout to speed up installation. UL Listed autoground. Fixtures are automatically grounded as soon as the access plate is snapped in place. No ground leads to connect. Auto-latching springs allow for an easy, secure connection and prevent accidental disengagement. Order RELOC factory wiring options for recessed ceiling and open ceiling applications. RELOC RELOC Recessed & Open Ceiling RRL - RELOC Ready Luminaire RRL Standard Wiring Instructions Add to Fixture Description Product Detail RRL Ballast/Driver wired to Pin Position #1 (Phase A) RRLA Touch-safe design meets UL/CSA require- ment Ballast/Driver wired to Pin Position #2 (Phase B) RRLB Wiping contact design allows safe disconnect under load Ballast/Driver wired to Pin Position #3 (Phase C) RRLC Mating connector must be ordered with RELOC cable Outboard Ballast/Driver wired to Pin Position #1 (Phase A) RRLAB Inboard Ballast/Driver wired to Pin Position #2 (Phase B) Ballast/Driver wired to Pin Position #1 (Phase A) RRLAE Emergency Ballast/Driver wired to Pin Position #2 (Phase B) Ballast/Driver wired to Pin Position #1 (Phase A) RRLABE Ballast/Driver wired to Pin Position #2 (Phase B) Emergency Ballast/Driver wired to Pin Position #3 (Phase C) Ballast/Driver wired to Pin Position #1 (Phase A) C12S Low Voltage wire (Positive Purple)(Data1) wired to Pin Position #2 Low Voltage wire (Common Gray)(Data2) wired to Pin Position #3 Recessed Ceiling Series RELOC Cable Attached to Fixture Quick Flex and System 820 Standard Wiring Instructions Add to Fixture Description Product Detail Quick-Flex QFC 12/2G Ballast/Driver wired to Hot #1 (Phase A) QFC2_A RELOC cable is prewired to the fixture in the factory and shipped together. 12/3G Ballast/Driver wired to Hot #1 (Phase A), Cap Hot #2 QFC3_A 12/3G Ballast/Driver wired to Hot #2 (Phase B), Cap Hot #1 QFC3_B Available in varying lengths to suit most common fixture 12/3G Outboard Ballast/Driver wired to Hot #1 (Phase A) QFC3_AB spacing requirements. Inboard Ballast/Driver wired to Hot #2 (Phase B) 12/3G Ballast/Driver wired to Hot #1 (Phase A) QFC3_AE Cable length must be speficied (QFC211A or SSCD11A) UL Listed auto ground. No ground leads to connect Emergency Ballast/Driver wired to Hot #2 (Phase B) System 820 SSC D Ballast/Driver wired Hot #1 (Phase A) SSCD_A E Ballast/Driver wired to Hot #2 (Phase B), Cap Hot #1 SSCE_B E Outboard Ballast/Driver wired to Hot #1 (Phase A) SSCE_AB Inboard Ballast/Driver wired to Hot #2 (Phase B) E Ballast/Driver wired to Hot #1 (Phase A) SSCE_AE Emergency Ballast/Driver wired to Hot #2 (Phase B) D Ballast/Driver wired to Hot Conductor (Phase A) SSC_C12S Low Voltage wire (Positive Purple)(Data1) wired to Pin Position #2 Wiring LITHONIA LIGHTING COMMERCIAL INDOOR

Previous Page
Next Page