Product Selection Guide Page 1090 Product Selection Guide-11th Edition

PSG11 1090 PRODUCT INFORMATION POWER PRODUCTS Intended Use RELOC Floor Modules provide cost-effective, pre-wired solutions for power requirements and data interfaces for easy, adaptable installation and relocation in raised floor applications. Ideal for centers, clean-rooms, laboratories, and government buildings. Features carpet cut-outs Listings UL Listed; CSA approved. FMR40 Rectangular Floor Module www.relocwiring.com RELOC WIRING SOLUTIONS ADDITIONAL INFORMATION For additional product information, visit www.relocwiring.com. Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions (if provided) are shown in inches unless otherwise noted. Notes 1 Maximum four duplexes. Center plate is data (six RJ45 slots) standard. Any unused capacity will be supplied with blank gang plate covers. 2 All duplexes are 20A rated. 3 When 2DR1C 2GFCI1C is ordered, it will be shipped with a DC2N (two circuit, two neutral) input cable. 4 Order of device installation: 1) power, a) back plate, b) front plate, c) center plate; 2) data - center plate only with six data jacks. Intended Use RELOC Floor Modules provide cost-effective, pre-wired solutions for power requirements and data interfaces for easy, adaptable installation and relocation in raised floor applications. Ideal for centers, clean-rooms, laboratories, and government buildings. Features for power and two for data Listings UL Listed; CSA approved. FMR40P Series Power 1,2 Data 1 RELOC Connection Finish FMR40P (blank) Two duplexes; one circuit 3DR1C Three duplexes on one circuit 2DR1C 1IGW1C Two duplexes on one circuit; one IGW duplex on one circuit (blank) Two data plates with two RJ45 each (blank) 1' drop cable, 820 system PTO1 1' power tee, 820 system MC12/2G05 Hard-wire with MC cable, single circuit, 5' DC2N 1' drop cable, 820 system, two circuit, two neutral (blank) Black ORDERING INFORMATION Specifications subject to change. Example: FMR40P 3DR1C PT01 ADDITIONAL INFORMATION For additional product information, visit www.relocwiring.com. Drawings are for dimensional detail only and may not represent actual mechanical configuration. Dimensions (if provided) are shown in inches unless otherwise noted. 4" 10-1/8" 5-3/4" 4.03" 9.91" 7.91" Notes 1 Maximum three duplexes and two data plates. Any unused capacity will be supplied with blank gang plate covers. 2 All duplexes are 20A rated. Series Power 1,2 Data 4 RELOC Connection Finish FMR40 (blank) Two duplexes; one circuit 4DR2C Four duplexes; two circuits (one on each side) 2DR1C 2GFI1C Two duplexes on two GFCI duplexes on separate circuit/neutral 3 2DR1C 2GW1C Two duplexes on two IGW duplexes on (two separate RELOC cables (blank) One data plate with six RJ45 slots, data plate is in center position (blank) 1' drop cable, 820 system PTO1 1' power tee, 820 system MC12/2G05 Hard-wire with MC cable, single circuit, 5' DC2N 1' drop cable, 820 system, two circuit, two neutral (blank) Black BRN Brown BE Beige GY Gray Example: FMR40 4DR2C PT01 ORDERING INFORMATION Specifications subject to change. PRODUCT INFORMATION Rectangular Floor Module

Previous Page
Next Page