Product Selection Guide Page 1070 Product Selection Guide-11th Edition

Series Voltage # of devices Device type 2,3,4 Switching/Dimming Controls Wiring OCM 1-port OCM2 2-port 1 120 120V 277 277V 1 Sensor Switch nLight PP20 nPP16 SP20 nSP16 PP202P nIOD nIOIS LC&D X-Point nPS80 XP1 nPS150 5 XP2 nPS250 5 XPDIM (blank) Single level switching with unswitched hot 2LU Two level switching with unswitched hot 6 1LD Single level with dimming wires 7 (blank) Not required C12S Integrated CI, CII rated line voltage and signal wires 8,9 PSG11 1070 PRODUCT INFORMATION MODULAR SYSTEM OnePass www.relocwiring.com RELOC WIRING SOLUTIONS Intended Use Modular wiring to cover the most demanding low and high temperature environments (-40C to 75C). Extend savings with OnePass EXTREME to warehouse coolers and freezers, food distribution and unheated facilities. Features and controls Listings UL Listed to U.S. and Canadian safety standards. ONEPASS EXTREME ADDITIONAL INFORMATION For additional product information, visit www.relocwiring.com. ORDERING INFORMATION Specifications subject to change. Example: OCM 277 1PP20 Notes 1 OCM2 always carries unswitched power through on parallel port and switched output on the switched/dimming port. 2 Refer to the Controls's device type spec sheets for temperature and local code requirements. 3 Consult factory for use with other controls devices. 4 nLight devices 16-amp rated. 5 nPS150 & nPS250 is used only when the nLight graphical wall switch is used (nPOD GFX). 6 2LU option can only be used with the PP202P & XP2. 7 1LD option valid with C12S and nIOD options only. 8 C12S option used only with other OnePass system components require the integrated CI, CII controls wiring. 9 Consult factory for deep dim applications when <10% dimming is required for use with non-Acuity Brand fixtures. Series For OnePass EXTREME simply add "EXT" on the end of all OnePass ordering nomenclature. ORDERING INFORMATION Specifications subject to change. Example: OC2 277 12/4G 09 EXT PRODUCT INFORMATION OnePass Control Module Intended Use Seamlessly integrates Sensor Switch, nLight and LC&D X-Point relays and control devices into the OnePass wiring system allowing for zone level or luminaire level switching and dimming control. Features thermoplastic insulation rated 600V with different voltages Listings UL Listed. OCM

Previous Page
Next Page